Repair Guides Garbage Disposals

Garbage Disposal Jammed or Humming on Thanksgiving? How to Unjam It and What Not to Put Down It

Garbage disposal jammed or humming on Thanksgiving? Switch it off, turn the hex wrench under the unit, press reset, and keep grease, peels and bones out of it.

Stainless steel kitchen sink with a disposal drain stopper, stacked dinner plates, a bowl of vegetable peels and a roasting pan nearby.

If your garbage disposal is jammed or humming on Thanksgiving, switch it off, put the hex wrench into the hole in the center of the unit’s bottom, and work it back and forth until the grinding plate spins freely. Then pull out the object with tongs, let the motor cool for a few minutes, press the red reset button on the bottom, and test it with cold water running. The best way to avoid all of this is to keep grease, piles of potato peels, celery, and the turkey carcass out of the disposal in the first place.

This matters more this week than any other. Roto-Rooter says the day after Thanksgiving, which plumbers call “Brown Friday,” is its busiest day of the year, with about 50% more service calls than an average Friday, and the Thursday-through-Sunday holiday weekend averages about 21% more calls than a typical one. Clogged kitchen sinks and jammed garbage disposals top its list of Thanksgiving problems. (Those figures come from Roto-Rooter’s historical service data, published in its November 2025 release.) Thanksgiving falls on November 26 in 2026, so you have a week to get ahead of it.

The steps below come from InSinkErator’s support pages and manuals. Other brands work similarly, but check your manual, because some models differ.

Why is my garbage disposal humming but not grinding?

A hum with no grinding usually means the motor is getting power but the grinding plate can’t turn, because something is wedged between the plate and the grind ring. On a holiday that is often a bone, a fruit pit, a bottle cap, or a utensil that slid off a plate. InSinkErator’s jam video covers exactly this case: jammed, humming, stuck, or stopped.

Switch it off right away. Running a jammed motor is what trips the overload protector, which is why a humming disposal often goes silent a few seconds later.

How to unjam a garbage disposal (InSinkErator’s steps)

Every InSinkErator ships with a self-service wrench, called the Jam-Buster wrench: silver, crank-shaped, about four inches long. If you can’t find it, a standard 1/4-inch Allen wrench fits.

  1. Switch it off. Turn off the disposal and the water. If the sink is full, let it drain or bail it out with a pot.
  2. Find the hex hole. It’s under the sink, dead center on the bottom of the disposal, facing the floor.
  3. Work the wrench. Use it like a crank, back and forth in both directions. InSinkErator says it’s fine to use some force; the wrench is designed to bend before the disposal is damaged. Keep going until it turns freely in full circles both ways.
  4. Look inside. Shine a flashlight into the grinding chamber, paying attention to the outer edge of the shredding plate where the small teeth are. Lift out anything you see with tongs or pliers.
  5. Press reset. InSinkErator’s Badger manual says to let the motor cool for 3 to 5 minutes, then lightly push the red reset button (more on that below).
  6. Test it. Turn on cold water, then the disposal. If it jams again, repeat the wrench step. InSinkErator notes it can take several tries.

Builder Series, Amana, ES and EZ Connect units

Some InSinkErator lines work differently:

  • Builder Series, Amana and ES units: with the disposal and water off, free the jam from above by rotating the turntable in either direction with a wooden spoon, then remove the object with tongs.
  • EZ Connect units: use the small wrenchette in the bottom center hole until it turns one full revolution.
  • Both have an automatic overload switch instead of a button you press. Turn the wall switch off and let the disposal cool for up to 20 minutes before turning it back on. If yours runs from a push-button air switch on the sink or counter, turn it off and unplug the disposal for up to 20 minutes.

Garbage disposal won’t turn on at all? Check the reset button and breaker

If the disposal makes no sound at all when you flip the switch, the overload protector has probably tripped, or the circuit has.

  • Find the reset button. On InSinkErator units it’s a small square red button on the bottom of the disposal, facing the floor. When it has tripped, it drops down about a quarter inch (5 mm).
  • Press it gently. If it won’t stay in, wait 10 minutes and try again. The motor has to cool first.
  • Check the breaker. If the motor still won’t run after a reset, InSinkErator says to check your service panel for a tripped breaker or blown fuse.
  • Clear the jam first. If the button keeps tripping as soon as you run the disposal, something is probably still wedged inside. Go back to the wrench step.

What not to put down a garbage disposal on Thanksgiving

Most Thanksgiving disposal calls start with what goes into the sink during cleanup. Here’s what InSinkErator and Roto-Rooter say to keep out:

Keep out of the disposalWhyDo this instead
Grease, turkey drippings, cooking oil, fatIt can cool and build up inside pipes, and InSinkErator says never to pour it into a disposal or any drainLet it cool in a jar or can and put it in the trash; wipe greasy pans with a paper towel before washing
Hot grease or other hot liquidsInSinkErator lists them in the do-not-put listCool and trash grease; it’s fine to drain hot water between grinding sessions
Turkey carcass and large bonesRoto-Rooter says bones can damage or jam disposals; InSinkErator’s foodservice manual lists large bones as a noTrash or stock pot
Poultry skinRoto-Rooter says it is hard to break down and can contribute to clogsTrash
Large amounts of potato peels and other starchy food (mashed potatoes, rice, pasta, stuffing)Starches can form a thick, sticky mixture in the drainScrape plates into the trash or compost
Celery, corn husks, artichokes and other stringy or fibrous scrapsThey can tangle in the disposal; InSinkErator says its Standard Series models can’t grind stringy, fibrous foodTrash or compost
Shells, glass, china, plastic, plastic wrap, metal (bottle caps, utensils)InSinkErator lists them as items never to put in a disposerKeep the sink stopper in when the disposal isn’t running
Caustic drain cleanersInSinkErator says not to put them in a disposerClear jams with the wrench; call a plumber for a drain-line clog

InSinkErator’s Badger manual says its household disposals can grind small bones and fruit pits, but that doesn’t extend to a turkey carcass.

How to use a garbage disposal during holiday cleanup

The way you feed the disposal matters as much as what goes in. From InSinkErator’s manual and Roto-Rooter’s tips:

  1. Cold water first, then the disposal. Run a moderate flow of cold water and keep it running for several seconds after grinding stops, so the ground waste flushes down the drain line. InSinkErator says to avoid hot water while grinding.
  2. Feed scraps gradually while it runs. Don’t pack the disposal full and then switch it on. InSinkErator specifically says not to fill it with a lot of vegetable peels at once.
  3. Let it finish. Don’t switch it off until you only hear the motor and water.
  4. Scrape plates into the trash first. Roto-Rooter’s advice for Thanksgiving is that most food scraps are best tossed in the trash or compost, not rinsed into the sink.
  5. Space out showers and laundry. With overnight guests, Roto-Rooter suggests spreading out showers and laundry loads so the drains aren’t all running at once.

If your dishwasher drains through the disposal, a clogged disposal can also leave standing water in the dishwasher. See dishwasher not draining for that side of the problem, and 8 fixes for a dishwasher that isn’t cleaning before holiday hosting before the big load.

Before Thanksgiving: a 5-minute disposal check

Roto-Rooter says many Thanksgiving clogs start as a partly blocked drain that keeps working until holiday use finishes it off. A few days before the meal:

  • Run a test. Cold water on, disposal on, and watch how fast the sink drains. A slow drain now will be worse on Thursday night.
  • Find the wrench. Locate the Jam-Buster wrench (often taped to the unit or in a kitchen drawer) or a 1/4-inch Allen wrench, and keep tongs and a flashlight nearby.
  • Clean out odors. InSinkErator’s manual says an odor usually means food buildup. Put the stopper in, fill the sink halfway with warm water, mix in 1/4 cup of baking soda, then turn on the disposal and pull the stopper at the same time to wash loose particles away.
  • Look for leaks. InSinkErator recommends inspecting the disposal and its plumbing fittings regularly, because a leak can cause property damage.

For a full year of appliance upkeep, see the maintenance calendar. If you’re on a septic tank and thinking about a new unit, our guide to garbage disposals for septic systems covers what EPA says.

If the kitchen sink backs up on Thanksgiving

Roto-Rooter’s advice when the sink stops draining:

  1. Stop running water into that sink, and don’t keep running a disposal that seems jammed.
  2. Try a sink plunger if the clog is limited to that one sink.
  3. Skip chemical drain cleaners, especially in standing water.
  4. If several drains back up at once, stop using water everywhere in the house, including toilets, showers, the dishwasher and the washer. Multiple fixtures backing up together can point to a main sewer line blockage. Stay away from sewage-contaminated water.

When it’s probably not a DIY fix

Call a plumber or a qualified technician if:

  • The disposal still won’t run after you’ve cleared the jam, pressed reset, and checked the breaker.
  • The reset button trips again every time, even with the grinding plate turning freely.
  • Water is dripping from the disposal body or its fittings.
  • Several drains are slow or backing up, gurgling, or smell of sewage, which can mean a main line problem rather than the disposal.
  • You smell burning or see damaged wiring. Don’t touch the electrical connections yourself.

Step-by-step summary

Time
About 30 min
Tools
Jam-Buster wrench or 1/4-inch Allen wrench, Flashlight, Long-handled tongs or pliers, Wooden spoon (Builder Series, Amana and ES units)
  1. Switch the disposal off. Turn the disposal switch off and turn off the water. Never put your hand inside the disposal. If the sink is full of water, let it drain or bail it out first.
  2. Free the grinding plate from below. Put the wrench into the hex hole in the center of the disposal's bottom and work it back and forth until it turns freely in full circles. On Builder Series, Amana and ES units, rotate the turntable from above with a wooden spoon instead.
  3. Remove the object. Shine a flashlight into the grinding chamber and lift out whatever caused the jam with long-handled tongs or pliers, not your fingers.
  4. Let the motor cool and press reset. Wait 3 to 5 minutes, then gently press the small red reset button on the bottom of the disposal. If it won't stay in, wait 10 minutes and try again. Units with an automatic overload switch need up to 20 minutes to cool instead.
  5. Check the breaker if it still won't run. If the motor stays silent after a reset, check your service panel for a tripped breaker or blown fuse.
  6. Test with cold water running. Turn on a moderate flow of cold water, then the disposal. If it jams again, repeat the wrench step; it can take a few tries.

Frequently asked questions

Why is my garbage disposal humming but not working?

A disposal that hums but doesn't grind usually has power to the motor but a jammed grinding plate. Switch it off, turn the hex wrench in the hole on the bottom until the plate spins freely, remove the object with tongs, then press the red reset button.

Where is the reset button on a garbage disposal?

On InSinkErator disposals it is a small square red button on the bottom of the unit, under the sink, facing the floor. When the overload protector has tripped, the button drops down about a quarter inch.

Can you put turkey bones in a garbage disposal?

Put the turkey carcass and large bones in the trash. InSinkErator says its household disposals can grind small bones, but Roto-Rooter warns that poultry bones can damage or jam disposals and lists jammed disposals among the most common Thanksgiving plumbing calls.

Can you put potato peels down the garbage disposal?

Not in large amounts. InSinkErator says not to fill a disposal with a lot of vegetable peels at once and to feed them in gradually with the water and disposal running. Roto-Rooter recommends putting potato peels and other starchy scraps in the trash or compost on Thanksgiving.

Can I use drain cleaner in a garbage disposal?

No. InSinkErator lists caustic drain cleaners among the things not to put into a disposal, and Roto-Rooter advises against pouring chemical drain cleaners into standing water. Unjam the disposal mechanically, and call a plumber for a clog in the drain line.

Why is the day after Thanksgiving called Brown Friday?

Plumbers call the Friday after Thanksgiving Brown Friday because it is their busiest day of the year. Roto-Rooter says it gets about 50% more service calls that day than on an average Friday, with kitchen sink clogs and jammed disposals near the top of the list.

Sources

garbage disposal jammedgarbage disposal humminggarbage disposal reset buttonThanksgivingBrown Fridaykitchen sink clogInSinkErator

Found an error? We correct mistakes promptly. See our corrections policy.